Virtual Meter Instructions

Main Menus

Select & Scale Input
  1. Select Thermocouple or RTD Input
    1.   Input
      Type
      Display Key
      R
      T
      D
      JPtB Arrow Up Arrow Down
      JPtA Arrow Up Arrow Down
      PtC Arrow Up Arrow Down
      PtB Arrow Up Arrow Down
      PtA Arrow Up Arrow Down
      T
      H
      E
      R
      M
      O
      C
      O
      U
      P
      L
      E
      Platinel II Arrow Up Arrow Down
      W Arrow Up Arrow Down
      U Arrow Up Arrow Down
      N Arrow Up Arrow Down
      L Arrow Up Arrow Down
      S Arrow Up Arrow Down
      B Arrow Up Arrow Down
      R Arrow Up Arrow Down
      T Arrow Up Arrow Down
      E Arrow Up Arrow Down
      J Arrow Up Arrow Down
      K2 Arrow Up Arrow Down
      K1 Arrow Up
      Press and hold Set/Ent for 3 seconds to enter the setup menu.
    2. Press Down three times to reach the lockout password, .
    3. Press Set/Ent to enter the lockout password (the default is 0).
    4. Press Down to access  (Input Group).
    5. Press Set/Ent to access parameter  (Input Type).
    6. Press Up to select the input type based off the following table.
      Note: Changing a parameter setting will cause it to flash.
    7. Once the input type is selected, press Set/Ent to accept the input type.
    8. Press Set/Ent to access parameter  (Input Units).
    9. Press Up and Down to change the temperature unit if desired.
    10. Press Set/Ent to accept display unit if changed.
    11. Press and hold Set/Ent for 3 seconds to exit the setup menu.
  2. Select & Scale a Voltage Input
  3. Select & Scale a 4-20 mA Input
The Nova VirtualMeter assumes a 22°C or 72°F ambient temperature while programmed for a temperature input.